Markus_d

I just flashed to new NF4LD329 bios and I didn't gain enything, exept new memtest and some small updates in bios... My overclock is still maxing out the same... I used 623 bios before this new one. //M_d

HI ! I have the exact same CPU. My cpu hit a load temp around 50c too with only like 1.45vcore. I removed the IHS and now the temp are great Load temp is around 43c now, with 1.48vcore It hits 50c when I put like 1.65-1.7vcore, thats nice Using a scythe ninja cooler with a 120mm everflow fan.

try running cpc on, it gives you much more performance...

http://downloads.guru3d.com/download.php?det=725

try scanning artifacts with atitool, and chech your volts and your rails, maybe the psu is the problem... also, you don't have to worry about getting deeper in the ., not if you just set the specified settings manually. thats just to ensure that everything is running as specified by manufacter.

have you tried setting timings and klocks manually in bios ? maybe you need to set them to the specified timings and volts in bios, and try to raise the volts to mem and cpu... also, download some kind of artifact scanning program to test the gfx. maybe atitool works om nvidia also ? i think so...but not 100% sure... start with setting all klocks and timings manually in bios, before you start testing... update bios if you haven't done so... also, check so all the power cables are in place..

http://www.vrforums.com/showthread.php?t=47615 some pics

BH-5 doesnt boot with CL3 you can always check the chips, try finding a pic on the web to compare with.

1.58v with good temps will let your core live long i think... maybe you should drop it down to 1.54-1.56v...

what does bios report for voltage when you run it @ 1.52v windows...

Try running OCCT Torture for 10-20h. I ran a test and it passed, and then i thought I burn my cpu in a bit...errored after 6 hours. After upping the vcore it errored after 10 hours. Now im on a new config, cuz I couldn't get it stable, it bluescreened on me some times and acted wierd... Ran OCCT Tortur for 21h, yesturday and it didn't error on me, so it feels pretty stable so far, yet to be seen if it bluescreens on me again

yes, do so... it will give you 1.552v windowa read, but something like 1.59v in bios i think.. but if you do not gain anything, drop it down to your current setting..

did you mod the bracket ? if not, do so...it will get you the tension you need... good to see you pushed your GFX to

try dropping your multiplier on the cpu, and see if you can run higher HTT. also, I run 1.6v right now and im burning in @ 10*302. there is no problem with 1.6v...

change the divider to 133 and try it out... try pushing using 1.450*110% on the cpu