RHKCommander959 Posted November 7, 2011 Posted November 7, 2011 I can't tell whats dust/dirt, electrolytic goo, and burnt but if that is just goo you might get lucky and only have a bad cap. Clean the area up and take a better photo unless that is burnt damage on the VRM then don't worry about it. Capacitors are simple to replace just have patience if it is your first time Share this post Link to post Share on other sites More sharing options...
ir_cow Posted November 7, 2011 Posted November 7, 2011 it's the VRM, i'm guessing the paste did the damage. Share this post Link to post Share on other sites More sharing options...
MJCRO Posted November 7, 2011 Posted November 7, 2011 Ouch. Share this post Link to post Share on other sites More sharing options...
sticknstone Posted November 8, 2011 Posted November 8, 2011 The reason thermal paste is not the best for tim in this instance is because the installation of the ic chips on the board do not need to be the same height. The only concern for the installer is making a connection on the mobo so the current will flow; Therefore, the first chip may be 1.5mm high, and the next chip may be 1.75mm high etc..... Now if a flat vrm block is placed on these chips of different height without taking into account contact to the block the end result will be as is seen in the first post. What size pad will be needed in this installation will require examination of the surface to which the block is installed and ensuring that any air gaps are eliminated. What was used when the stock cooler was installed? Most likely nothing. Overclocking will require more meticulous care with cooling! Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now