thoughts on my oc...

[bisonator]

currently at 250x10 (LDT 3x)

memory at 9/10 divider = 225mhz 2.9vdimm and 2.5-2-2-10

 

cpu temp (according to mbm5) idle 41c and load 61c (I think the temps are reported 5-10c too high compared with my epox board) (heatsink temp idle 26c and load 32c)

 

sys temp (according to mbm5) idle 29c and load 32c

 

air temp in case (measured with probe) idle 19c and load 20/21c

 

Now, I know this RAM can do 240 2.8vdimm 2.5-2-2-10 (in my old epox 8kda3+) BUT it seems it cannot do 250mhz at 2.5-2-2-10, 3-2-2-10, 2.5-3-3-10. Although it boots it these settings it stops half way to windows.

 

Ideally i'd like 250 x10 1:1, so i will try 3-3-2-10 and 3-3-3-10, though, if i can't get the ras-cas at 2, i may try to keep my memory at 2.5-2-2 240.

 

any thoughts?

[RGone]

The Ballistix 4000 I had would do 265 or so on an 8x multiplier and had to have 3.2volts on the memory. I have swapped it off for some 3200 stuff and it should be here in the next few days. The 3200 stuff is supposed to have a different programming on the stick. Maybe maybe not. Hope I did not trade off my better stuff.

 

It does not matter what thoughts any of us might have but what are you going to tweak to and bench and see if is stable? That is the real question.

 

 

RGone...

[bisonator]

Originally posted by RGone

The Ballistix 4000 I had would do 265 or so on an 8x multiplier and had to have 3.2volts on the memory. I have swapped it off for some 3200 stuff and it should be here in the next few days. The 3200 stuff is supposed to have a different programming on the stick. Maybe maybe not. Hope I did not trade off my better stuff.

 

It does not matter what thoughts any of us might have but what are you going to tweak to and bench and see if is stable? That is the real question.

 

 

RGone...

 

well, you almost answered what i was asking. similar setups to mine with different configs that I could try... but still I will keep testing.

 

regards.

[trickson]

got minr to 2.64Ghz .. it rocks!!!