w0w* Posted August 22, 2005 Posted August 22, 2005 This is a quick question but i have a chieftec dragon case with the clear side window and i was planning on cutting a 120mm hole on the bottom left but i was wondering wuts the best possible way to cut it? I have never used tools but whichever is the easiest and most effective please let me know THANKS Share this post Link to post Share on other sites More sharing options...
Guest Raven65 Posted August 22, 2005 Posted August 22, 2005 use a template and then trace the hole then you can use a hole saw or a dremel. just put tape a little bit larger than the hole to stop it from splintering. Share this post Link to post Share on other sites More sharing options...
w0w* Posted August 22, 2005 Posted August 22, 2005 In ur opinion, would u use a holesaw or a dremel? Share this post Link to post Share on other sites More sharing options...
martymcfly Posted August 22, 2005 Posted August 22, 2005 holesaw is much easier, but less versatile. Share this post Link to post Share on other sites More sharing options...
kobalt Posted August 22, 2005 Posted August 22, 2005 (edited) holesaw is much easier, but less versatile. 531951[/snapback] Yeah a hole saw is a one trick pony but cost a lot less than a dremel AND a dremel in plastic is a bit messy, turns at about a gazillion turn a second and dosn't cut but melts the plastic and simply closes the cut section behind it loll. I'd go with a hole saw, but if it was me i'd buy a slightly smaller size and finish it off with a semi round coarse file and then sanding paper.That way you're sure not to have small heat cracks from the hole saw on your window.Better take your time than to have a window you wont like Btw raven is right about the tape,always tape your window when you use a hole saw and use a small bit to do your center first so your hole saw center piece have somewhere to anchor itself (did you like that one "anchor itself" lolll ) Edited August 22, 2005 by kobalt Share this post Link to post Share on other sites More sharing options...
robAP Posted August 22, 2005 Posted August 22, 2005 if you have a router bit for the dremel its MUCH easier. with the router bit only turn it on at 7 or 8 setting and slowly work your way around. get a round file and clean it up to the edge of the circle you drew and you should be fine. if you have the router bit fo rthe dremel, you should have that base for it too thatll keep your edges square. Share this post Link to post Share on other sites More sharing options...
suchuwato Posted August 22, 2005 Posted August 22, 2005 Use a fine toothed holesaw and use an adhesive plastic / masking tape or whatever to stop nasty edges, then just use some polish and a soft dremel bit on the inside to finish. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now