GerardJg Posted March 19, 2007 Posted March 19, 2007 Hello and Thanks in Advance Here are the Specs NF4 Ultra D 4600 X2 PC P&C 510 sli Saphire X1600XT WD Raptor Ram Tried Kingston Hyper X 3200 BH5 512, Corsair XMS 2700 256, KinMax 3200 256 I followed everyones advice and started this project on the MB Box. CPU in 1 stick memory in slot 2 Vid card in only floppy and hard drive pwered All power cables plugged in and all jumpers in the default settings. The first boot all fans came on the red leds on and went out as it booted The Lan Party Logo was on my screen and that was it. Ever since then all I get is the moment I plug the PSU in the Vid card fan starts to spin momentarily, The 4 red leds and the memory led plus the 2 leds on the vid card flash instantly and the amber power light stays on. The power switch does not do anything at this point. I individually tried all of the above ram in every position numerous times, I did the 24 hour CMOS clear to the letter with no help. :confused: :confused: :confused: BTW The board and CPU were purchased on Ebay The seller says board is unused from RMA and CPU is 2 months old, and of course worked fine for him. Any thoughts would be greatly appreciated Share this post Link to post Share on other sites More sharing options...
uneedav8 Posted March 20, 2007 Posted March 20, 2007 Is all four power connectors plugged into the motherboard? Try the power switch on the MB itself. Share this post Link to post Share on other sites More sharing options...
GerardJg Posted March 20, 2007 Posted March 20, 2007 Yes all 4 plugs are in and I am using the mother board switch Share this post Link to post Share on other sites More sharing options...
MACarter02 Posted March 20, 2007 Posted March 20, 2007 try switching off and on the power supply a few times. then try unplugging the 24 pin, and reseating it. Share this post Link to post Share on other sites More sharing options...
GerardJg Posted March 20, 2007 Posted March 20, 2007 try switching off and on the power supply a few times. then try unplugging the 24 pin, and reseating it. I Probably wore out the plug doing that this past weekend and will not get to it again until Friday, Plan on picking up a larger PSU before I get home OCZ or Corsair and hope that this is the problem Thanks Share this post Link to post Share on other sites More sharing options...
dr_bowtie Posted March 20, 2007 Posted March 20, 2007 Try using each ram slot and see if it will post... I just got my sli-dr back and it wouldnt post with one stick in the orange slot closest to the cpu...which is weird... but as soon as I added the second stick it booted fine... Share this post Link to post Share on other sites More sharing options...
GerardJg Posted March 23, 2007 Posted March 23, 2007 I did a long 48 hour cmos clear put in some crucial 2700 hit the power button all fans turned on the CPU led went out the other 3 stayed on, Shut the power off and back on and now nothing at all when I press the power button. I also tried a corsair 620 psu and a 3000 venice same results Board or Video Card???? Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now