links between dram settings and cpu overclocking

[kitfit1]

FSB Bus Frequency............................. - 300

LDT/FSB Frequency Ratio....................... - 3x

CPU/FSB Frequency Ratio....................... - 10x

PCI eXpress Frequency......................... - 101Mhz

 

CPU VID StartUp Value......................... - 1.500v

 

CPU VID Control............................... - 1.400v

CPU VID Special Control....................... - 116.8%

LDT Voltage Control........................... - 1.20v

Chip Set Voltage Control...................... - 1.52v

DRAM Voltage Control.......................... - 2.68v

 

DRAM Configuration Settings:

DRAM Frequency Set............................ - 10

Command Per Clock (CPC)....................... - Enable

CAS Latency Control (Tcl)..................... - 3

RAS# to CAS# delay (Trcd)..................... - 4

Min RAS# active time (Tras)................... - 8

Row precharge time (Trp)...................... - 4

Row Cycle time (Trc).......................... - 13 Bus Clocks = lower to 7

Row refresh cyc time (Trfc)................... - 16 Bus Clocks = raise to 19

Row to Row delay (Trrd)....................... - 03 Bus Clocks

Write recovery time (Twr)..................... - 03 Bus Clocks

Write to Read delay (Twtr).................... - 02 Bus Clocks

Read to Write delay (Trwt).................... - 03 Bus Clocks

Refresh Period (Tref)......................... - 3120 Cycles

DRAM Bank Interleave.......................... - Enabled

 

DQS Skew Control.............................. - Increase Skew = change to auto

DQS Skew Value................................ - 221 = change to 0

DRAM Drive Strength........................... - Level 8 = lower to 7

DRAM Data Drive Strength...................... - Auto = change to 4

Max Async Latency............................. - 8.0ns = change to 10.0ns

DRAM Response Time............................ - Normal

Read Preamble Time............................ - 5.5ns = change to 7.5ns

IdleCycle Limit............................... - 128 Cycles = change to 256 Cycles

Dynamic Counter............................... - Disable

R/W Queue Bypass.............................. - 16 x

Bypass Max.................................... - 07 x

32 Byte Granularity........................... - Disable(4 Bursts)

 

Try the altered settings i've put in and see if that get's you further.

[Praz]

man....i was told to post settings here when i originally started a thread for help re: unstability then that thread got closed ?

You've been posting in 3 separate threads with the same problem. You have this one and the one in the 3G thread left. Decide where you want to post here or there. Not both.

[Supercharged]

i am just asking abt dram settings and its links with cpu stability in this thread. because i realise no matter what settings i used, it just doesnt help make it stable.

 

2.9ghz thread was asking abt the stability issues.

 

nvm then.