tbone2sk
Members-
Posts
957 -
Joined
-
Last visited
About tbone2sk
- Birthday 06/28/1988
Gaming
-
Xfire
tjohnson1988
-
Steam
tbone1988
Contact Methods
-
AIM
tbone 2sl
- Website URL
-
ICQ
0
OCC
-
Computer Specs
dfi NF4
3200+@2480 (305x9)
1gb PQI 2.5/3/3/6
OCZ 520w powerstream
x850xt 730/665
Profile Information
-
Location
Milwaukee WI
tbone2sk's Achievements
Newbie (1/14)
-
Overclocking A Naked Opteron 165 On A Dfi N4 Sli-dr Expert
tbone2sk replied to ApocFrenzy's topic in Overclocking and Cooling
most of the settings are the same http://www.dfi-street.com/forum/showthread.php?t=20823 -
Overclocking A Naked Opteron 165 On A Dfi N4 Sli-dr Expert
tbone2sk replied to ApocFrenzy's topic in Overclocking and Cooling
The DFI expert is not good when it comes to overclocking tccd, but you might have UCCC. Did you buy the ram in 1 2gb set, or 2 1gb sets? If it is UCCC chips, which normally comes in 1 2gb set, use these memory settings. download A64 tweaker -
Download from gamershell.com is fast
-
My naked 3000 venice running no divider If you guys are going to post superpi times, atleast post a cpuz too.
-
The infinity would be perfect if you are not overclocking. I would go with duel 7800gts, because duel 6800gts at this time are pointless.
-
First you have a crapy psu, and there is no way to control the fan speeds. If you want you can open up your psu and put in a better fan, or run the fan on 7v instead of 12v. The the easiest thing to do is get a better psu, becuase if that thing craps out then all your components might too.
-
I dount it is that hot. Put your hand behind the psu and see if the air coming out is burning your hand.
-
I bet that your venice can do 2700mhz, mine does 2800 (312*9). Download maxTcase and post what it is, for my venice it is 55*C http://www.short-media.com/download.php?d=473
-
I would not run tccd over 2.9, between 2.8 and 2.9 is good
-
This is the 4th pic with google image, searching is not that hard http://www.marnscda.com/Guide/Short20pin.jpg
-
Clean Carving Into Plexiglass
tbone2sk replied to supra411's topic in Cases, Power Supplies and Modding
Make a hot wirecutter, the plexi will get very hot and then just melt away. http://www.hhhh.org/~joeboy/resources/hotw...oam_cutter.html -
Clean Carving Into Plexiglass
tbone2sk replied to supra411's topic in Cases, Power Supplies and Modding
dermal low speed with mashingtape covering the top of the plexi -
My thinking is if you do have a baby in high school, abort it
-
There is the old slap on the butt, and then there is drunken rage.
-
Dfi Nf4 Ultra-d Bios Update
tbone2sk replied to matthewbolzicco's topic in Processors, Motherboards and Memory
that is what i was going to say, has helped me out a lot with trying out different bios's.