Kmoney
Members-
Posts
14 -
Joined
-
Last visited
Kmoney's Achievements
Newbie (1/14)
-
Hes allowed to post his results in your thread.
-
Do you have a good/great X2 overclock?
Kmoney replied to ixtapalapaquetl's topic in Overclocking and Cooling
Im at 3ghz on phase changing -
LanParty NF4 BIOS - Cleaned up 704-2bt a little
Kmoney replied to OCZTony's topic in Processors, Motherboards and Memory
Will there be a version with higher vcore coming soon? -
I just added this motherboard into my unit as my previos ULTRA-D died. The problem is that I can not make it into windows, my unit bluescreens right after the XP loading bar. Any ideas? Could it be my PSU [it did work fine on my previous unit]
-
I cant seem to get my cpu stable! Ive tried 200x13, 200x12, 250x10 and still it doesnt work. My mobile 2600+ use to do 2.6ghz, (200x13 at 1.9)on my nf7-s but then it stopped being stable so I upgraded to this board and im running 6/19 bios. My specs are in my sig. Ive only been running this chip maybe 5 days, does it need to be burned in? Also I cant get it stable past 1.95 volts. When I try 1.95 volts or higher the computer reboots (no bsod) after getting into windows. Please help. P.S My memory passes memtest86 at 250 3.3v, Also ive tried tones of different voltage combos.
-
Are the boards from China bad?
Kmoney replied to Kmoney's topic in Processors, Motherboards and Memory
Thank you for clearing that up, I did some research and found out they are just as good. Thank you! -
I just got my board and it is from china, is there any difference between the two? Are the boards from china not as good as the ones?
-
K I just added my specs
-
My board will be here tomorrow and im wondering if I should flash to the 6/19 bios. What improvments/fixes/changes are there from the last "official" bios?
-
Ok so I just recieved the 4th replacement board from DFI and it to is warped, 2 of my previous boards were warped and my last one was a victim of the notorious "4 leds of death" all in all this has a been a HORRIBLE expierence and has cost me about $22 to send the boards back. Come on DFI, where is your quality control?
-
Thermalright Neo Backplate Question!
Kmoney replied to Kmoney's topic in Processors, Motherboards and Memory
Thank you. . I have installed the heatsink on my abit nf7-s in the past I just didnt know about installing it in my new LAN Party board. -
Ok so I just recieved my Neo Backplate for my SLK-947U that im going to install on my Lan Party NFII Ultra "B". All that came with the Neo Backplate was the new backplate and the New Standoffs and the little mushroom head looking screws and the "C" rings. My question is, Can I use my old screws from my slk-947u to screw down the backplate but still use the new standoffs? Cause I did not recieve any new screws.
-
What model bios saviour work with the Lan Party NFII Ultra B?