AAHH!!kira Posted March 11, 2005 Posted March 11, 2005 Hey everybody! It's my first time on an english speaking forum (i'm french and my english is poor) I just bought an AMD 64 3000+ for upgrading my barton 2500+ configuration. I mount it include all alimentation include the floppy and other molex. When i push the start switch the fans turn on but there si no beep at all and three leds still glowing (i'm not sure of this word light maybe....) I have just mount the memory and the vga and swap all the rest. Then I try with the two ram sticks with all combination nothing work,with one (also tried each stick on each slot) it's not work too . The only way to have some beeps is to unplug the x800 or to put it on the second 16x slot. It's make 1 long beep and 3 short and three led light off but after the beeps the cpu fan comes off and nothingelse appen :confused: I think that' the fault off my scrappy 300w psu but i'm not sur that it isn't the X800 whose failing :eek: Thx in adavnce for the answers Share this post Link to post Share on other sites More sharing options...
cpuz Posted March 11, 2005 Posted March 11, 2005 Hi and welcome to the forum! Your english is very well by the way! Yes, it could be your power supply. 300 watts is not enough to power that motherboard and it is not a 24 pin. The enermax 550w will serve you much better. I don't even think there is any more reason to discuss the issue until you get that power supply! French Alps, huh? ...Odl lay ee, old lay ee Odl lay hee hee, odl lay ee Odl lay odl lay, odl lay odl lee, odl lay odl lee Odl lay odl lay odl lay HOO! :nod: Share this post Link to post Share on other sites More sharing options...
AAHH!!kira Posted March 11, 2005 Posted March 11, 2005 What a beautiful song but it's a swiss alps speciality... Yes i swear it's only the psu fault. Normally the new one will be in place monday. The week end will be long... Let's wait for the issue. Share this post Link to post Share on other sites More sharing options...
AAHH!!kira Posted March 15, 2005 Posted March 15, 2005 It's working now. But i'm not sure it's really the psu fault... :confused: I have put on the enermax but it's happen the same thing 3led lighten and stop at this point. I re-tried to put ram on slot n°2 ,move graphic card,etc.. I finally be a little contraried an i put the graphic card "violently" in place. Now it's working but sometime i need to unscrew the card remove and replace it however it's not booting This happen also if i place the mobo out of the box... I don't know if it was the fault of the x800 or the mobo pciex 16x connector... I'm going back this week-end to the shop where i buy it and make them test it. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now