Psywar Posted February 7, 2002 Posted February 7, 2002 Ok, I have a question I want to get like 8 of these LED's and I want to mount them to the side of my case. I will be using the 4 pin Molax cable to suppie them power. Unless anyof you know a better way of doing this.. My question is.. What Size resister should I use for that LED? thanks a ton.. Share this post Link to post Share on other sites More sharing options...
red930 Posted February 7, 2002 Posted February 7, 2002 depends if your going to use the 12volts power or the 7volts power from the molex connector? by the way.. i really like Cole and his products but don't buy the led's from him. 3 bucks for one.. plus shipping.. just go to your local radio shack and pick some blue one's up for about 2.50 for 2 and no shipping. Share this post Link to post Share on other sites More sharing options...
Psywar Posted February 7, 2002 Posted February 7, 2002 well.. i got a female molax cable i had cut off an old psu. and i was just gonna attatch like.. 8 or so LED's to that and plug the female molax in to a male molax.. n go from there.. and thanks ill check out my radioshack Share this post Link to post Share on other sites More sharing options...
bass_freak Posted February 11, 2002 Posted February 11, 2002 do you have any programs like electronic work bench to help you figure out voltages and placements of wire for best lighting? Share this post Link to post Share on other sites More sharing options...
ib_enviro Posted February 12, 2002 Posted February 12, 2002 bass_freak: do you have any links to voltage info?? cheers Share this post Link to post Share on other sites More sharing options...
bass_freak Posted February 12, 2002 Posted February 12, 2002 to find out yours computers voltage just use mother board monitor 5, electronic work bench is a program to make circuit boards. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now