Jump to content
Sign in to follow this  
Psywar

Led's question

Recommended Posts

Ok, I have a question

I want to get like 8 of these LED's and I want to mount them to the side of my case.

I will be using the 4 pin Molax cable to suppie them power. Unless anyof you know a better way of doing this..

My question is..

What Size resister should I use for that LED?

thanks a ton..

Share this post


Link to post
Share on other sites

depends if your going to use the 12volts power or the 7volts power from the molex connector?

 

 

by the way.. i really like Cole and his products but don't buy the led's from him. 3 bucks for one.. plus shipping..

just go to your local radio shack and pick some blue one's up for about 2.50 for 2 and no shipping.

Share this post


Link to post
Share on other sites

well.. i got a female molax cable i had cut off an old psu.

and i was just gonna attatch like.. 8 or so LED's to that and plug the female molax in to a male molax.. n go from there..

and thanks ill check out my radioshack

Share this post


Link to post
Share on other sites

do you have any programs like electronic work bench to help you figure out voltages and placements of wire for best lighting?

Share this post


Link to post
Share on other sites

to find out yours computers voltage just use mother board monitor 5, electronic work bench is a program to make circuit boards.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...