Is Enermax 600 5vsb? (whatever that is)

[levk]

I gotta set the jumpers straight on my mobo, but I can't find those words in enermax manual

[davidhammock200]

I gotta set the jumpers straight on my mobo, but I can't find those words in enermax manual

What is the question? :confused:

 

Are all 4 plugged in like this: http://www.dfi-street.com/forum/showpost.p...734&postcount=3

[levk]

Yeah, I plugged it all in and it works, it's just that there's a jumper on top left of the board that has to do with PSU (in the manual it's on the first page). It says if you have a 5vsb power supply set it like this and if you have something else like that. Mine's set to something else (I don't have a manual here, going to go look at dfi site - maybe they have a PDF)

[levk]

Found it here. If you go to page 6, it's on the bottom half "PS/2 Power Select."

 

JP7

Two settings: 1-2 5V (default); 2-3 5VSB

[levk]

While I'm at it, there's the same thing on USB on the next page (just two jumpers) - I don't know what to put there either.

[davidhammock200]

Yeah, I plugged it all in and it works, it's just that there's a jumper on top left of the board that has to do with PSU (in the manual it's on the first page). It says if you have a 5vsb power supply set it like this and if you have something else like that. Mine's set to something else (I don't have a manual here, going to go look at dfi site - maybe they have a PDF)

If everything is working, leave it alone! :nod:

 

+5VSB = +5 Volt Stand By, this is always on

as long as the PSU is plugged in & the switch on the PSU is "on".

This is what allows the the system to boot when you push the front case "on" button,

it also allows "wake on LAN" & other options.

 

Dave

[levk]

If everything is working, leave it alone! :nod:

 

Oh man! I was just getting started! XD

 

Thanks a lot!