-
Posts
21 -
Joined
-
Last visited
About :[[Deeto]]:
- Birthday 08/12/1978
OCC
-
Computer Specs
E4300@3,1Ghz Daily|Abit AB9QuadGT|Adata EE 1066+ 2 Gb Kit|Maxtor 200Gb|Tagan U25|Alby 8800GTS|Thermaltake Armor|BenQ 19" Wide
Contact Methods
-
Yahoo
deeto_s
-
ICQ
0
:[[Deeto]]:'s Achievements
Newbie (1/14)
-
Try checking it within bios mode... if problem still there then maybe you could try updatin' your bios...
-
Why would it fry on 2.3 v??? My ram is running on 2.3v at 545 timing 5-5-5-12 1T. And I mean daily... Voltage default at 2.0v. ... This my memory is not under any cooling at all except for heat spreaders..
-
Please comment on my calculations - e6750 OC
:[[Deeto]]: replied to jdmmaster's topic in Overclocking and Cooling
set your vdimm to 2.3 v if u want ur ram to go 533 mhz... ur proci too will need to raise the vcore... Note : gek proper cooling on proci n memory.. A strong fan would do just fine... -
Yes when I mean 2 stepp you go from 14 to 12... Ur ram can handle up to mem bus 400 Mhz so you don't have to worry about it... as u are using ddr2 the voltage can go up between 2.1 v to 2.4 v is a safe zone...
-
E4400? good processor to start with?
:[[Deeto]]: replied to mattwalter85's topic in Processors, Motherboards and Memory
I wouldn't buy that E4400 if I were u.. E4400 is hard to get it running on OC. I've tried a few of these proccesor E4400... I'll put my hands on E4300 or E4500 which is much2 better... -
Upgrading Computer - Looking For Comments.
:[[Deeto]]: replied to Mr. Patman's topic in Processors, Motherboards and Memory
For Adata don't buy the 1200+... It's bad... The one with D9GMH is the 1066+ mem bus. So make sure you get the 1066+... -
I think u should lower down that multiplier by 2 step... don't forget the HT Link is 1 step lower.. as for your proc voltage just go for default this time... what memory are using?
-
Upgrading Computer - Looking For Comments.
:[[Deeto]]: replied to Mr. Patman's topic in Processors, Motherboards and Memory
Why don't u use Adata extreme Edition?? 2 Gb kit... All of the chipsets are Micron D9GMH! -
so is the bit rate that's also different.. while 88gt has only got 256 bit...
-
scores can differ from one to the other...
-
must have a powerful display card I'd say...
-
I'd love to OC my system, but where do I start?
:[[Deeto]]: replied to Hangshai's topic in Overclocking and Cooling
Wow.. your cpu is obviously running too hot!.. my advice would be to change you mainboard. As you may have to look for a very nice power supply aswell coz this is damn important when your OCing.. when you have a standart power supply it could sooner or later damaged your other pripheral... -
Try installing from the recovery cd... If u don't have one then use vista bootable n install it with ur current laptop..
-
Calculate with this link... http://www.extreme.outervision.com/PSUEngine
-
Go for Abit IP35Pro Off Limits... Awesome... or for alternative Abit IX38 Quad GT...