daniel Posted December 31, 2006 Posted December 31, 2006 well.. im not sure about this.. but are the results that im getting ont eh -12.00, and -5.00 rail.. normal? (see attached file) Share this post Link to post Share on other sites More sharing options...
kingdingeling Posted December 31, 2006 Posted December 31, 2006 minus 12 and minus 5 volt rails can not be measured by the mainboards afaik, you would need a multimeter to check those. But also, don't believe software monitoring for your rails, use a multilmeter if you want to check them properly. Share this post Link to post Share on other sites More sharing options...
romeo55 Posted December 31, 2006 Posted December 31, 2006 minus 12 and minus 5 volt rails can not be measured by the mainboards afaik, you would need a multimeter to check those. But also, don't believe software monitoring for your rails, use a multilmeter if you want to check them properly. and check/confirm fast... 2v on the 3.3v rail is BAD and 12.45 on the 12v is borderline... What's your PSU? Share this post Link to post Share on other sites More sharing options...
fire_storm Posted December 31, 2006 Posted December 31, 2006 Some of those look wrong 3.3+ at 2.02? I don't even think your computer would running if it actually had that voltage running. Also the core 2 and the +5.00 and +12.00 seem off. I assume that is mbm5 that your using you should get another program because they stopped developing that program years ago unless you have an old computer I don't think it would support your chip set. Try using programs like speed fan or everest or your motherboard manufacturer probably has a motherboard program that monitors temps and voltages and other stuff. What are your system specs? Share this post Link to post Share on other sites More sharing options...
daniel Posted December 31, 2006 Posted December 31, 2006 well i installed the program that comes with my mother board.. and well things changed a lil... (btw i have a ultra x-connect) Share this post Link to post Share on other sites More sharing options...
romeo55 Posted January 1, 2007 Posted January 1, 2007 well i installed the program that comes with my mother board.. and well things changed a lil... (btw i have a ultra x-connect) those look fine, were those at load? Share this post Link to post Share on other sites More sharing options...
daniel Posted January 1, 2007 Posted January 1, 2007 (edited) hmm let me do a test.... ill post results soon... EDIT actually there is no need to post.. at load.. results are basically the same.... Edited January 1, 2007 by daniel Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now