CIB24 Posted June 24, 2010 Posted June 24, 2010 Hello, Thought it might be a good idea to share the undervolting capabilities of the 1055T. My figures will be a bit higher than those running their 1055T's at stock speed but this should give you an idea how overvolted they are at stock. Here are my overclocked figures, speeds, and stock voltages at different P-States: FSB: 250 NB/HT: 2000mhz Memory: DDR3 1667 mhz 7-8-7-24 2T 40 1.6v P4: 1000 mhz 1.225v P3: 1875 mhz 1.275v P2: 2750 mhz 1.325v P1: 3500 mhz 1.375v P0: 4000 mhz (turbo) 1.475v Adjusted votlages via K10Stat and Prime 95 stability testing: P4: 1000 mhz 0.7875v P3: 1875 mhz 0.9625v P2: 2750 mhz 1.1375v P1: 3500 mhz 1.325v P0: 4000 mhz 1.475v (can't test for stability so left voltage very high just in case) I was able to originally test for stability at each P-State with the following values 0.75v, 0.925v, 1.1v, 1.3125v but could not remain stable when the clocks were adjusting themselves between P-States. As you can see, stock speeds of 2800 mhz may only need about 1.1375v to 1.15v to run stable and I believe it is possible to boot 800 mhz at < 0.70v. One thing I almost forgot to mention, the Prime 95 stability testing was done for 15 minutes with P-States 2-4 and for 1 hour with P1. I felt that the slower speeds needed less testing since the processor will not allow the lower P-States to operate at 100% without bumping up to the next P-State. Finally, if anyone has any idea how I can test P0 for stability that would be great because I seriously doubt it needs 1.475v to run stable. Share this post Link to post Share on other sites More sharing options...
The Smith Posted June 24, 2010 Posted June 24, 2010 What if you limited your stress testing to 3 threads? It should then bump to 4GHz on these three threads. I'm not sure if it will work though. Or, you could simply deactivate TURBO CORE and make 4GHz your P1, 3.5 your P2, etc. Share this post Link to post Share on other sites More sharing options...
CIB24 Posted June 24, 2010 Posted June 24, 2010 Yeah, I tried to limit to 1-3 threads and I didn't see it working so then I just deactivated turbo core and stressed at 4 ghz. It was stable but I didn't like my temperatures so I have since bumped it down to 3.8 ghz for the turbo at only 1.4 volts. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now