e_lion_1 Posted November 22, 2007 Posted November 22, 2007 I've been off having an adventure with this RDX200 board I picked up. However, I can't seem to boot into WinXP or LFS when overclocked - I honestly don't understand why or what to change. Memtest passes with flying colors. Also, the CPU and RAM had been in my NF4 board OC'd with minimal problems. Any ideas? Bios Settings 250 MHz Disable x3 x10 1.425 Disable Software Reset Disable x16 Enable 1.250 126.4 % 2.8 1.8 1.3 1.3 1.3 DRAM settings 200 Enable 2.5 4 8 3 7 16 2 2 1 2 3071 Enable Auto 0 Level 11 Level 2 8 5 256 Disable 16 7 Disable :confused::confused::confused: Share this post Link to post Share on other sites More sharing options...
ponderingpete Posted November 22, 2007 Posted November 22, 2007 You say, "can't seem to boot into when overclocked." So...when at stock all is OK? What have you done since swapping boards? Share this post Link to post Share on other sites More sharing options...
e_lion_1 Posted November 22, 2007 Posted November 22, 2007 yes, ponderingpete, the setup runs just fine at stock speeds. Rig #2 was a new build from scratch using some parts I had around (CPU, RAM, Powersupply) and new parts (RDX200, hard drive, video card). To be more exact, the OS starts booting up but then dies a few seconds into it, rebooting the computer in the process. Share this post Link to post Share on other sites More sharing options...
e_lion_1 Posted December 10, 2007 Posted December 10, 2007 So, after some searching, I discovered that most of the Winchesters in the overclocking database were running the ram on dividers...gave it a try and presto! everything works. My guess is that the memory controller on this cpu just doesn't like to be pushed too hard (esp. with the RDX200 board). Should anybody else have some thoughts, I'd like to hear them. Thanks! Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now