My Ultra-d only does 310 is that normal?

[malicious]

Ultra-d with the Oskar wu or whatever 702-2 bios

146

corsair bh5 2x512

7600gt

 

tdx

bip3

d5

maze4 gpu

 

xfinity 500w w/ all four plugs in

 

tried a 1/2 ram divider lowering ht multi to 2x cpu multi to 5x and jacked up htt and chipset voltage to max 1.8 on the chipset

 

if i push clockgen past 311 it says blink restart

[mothow]

Thats your cpu's limit not the board's.Try dropping the cpu's multi down to like 9 or 8 then you should be able to run a higher FSB .But your ram is only good for around 250/260 with 3.5/3.6volts or so. If i were your id run it at say 12x260x4 with your ram 1:1 and timming as tight as possible which with3.5/3.6v and an active fan should get you 2-2-2-5-T1 at around 250 to 260 fsb or so.Remember BH5 likes voltage

[thefabe]

Read thru the defenitive overclocking guide see if it will help you any http://www.dfi-street.com/forum/showthread.php?t=20823

[old_geekster]

if i push clockgen past 311 it says blink restart

Welcome to the "Street"!

 

It is not recommended using software programs, such as "clockgen", to OC DFI boards. You should use the BIOS.

 

Read the OC guide, then re-read it again. It will help you understand the process and the settings.

[malicious]

well i read somewhere that you can set your cpu and ldt multi too low so i bumped them up to 3x and 7x and was primeing for an hour at 350

 

all is better

 

thanks

 

 

 

oh.. i tried 355 and she froze so 350 it is...

 

mal

 

 

edit: i actually lowered my vchip down to stock it it's primeing now at 360

 

i'll read the guid thourghly now several times before asking another question ...

 

just and eager beaver lol

 

thanks guys

 

mal