red930 Posted October 24, 2006 Posted October 24, 2006 DFI LP UT NF590 SLI-M2R/G Socket AM2 NVIDIA nForce 590 SLI MCP ATX AMD Motherboard BIOS 8/29 AMD Athlon64 X2 Windsor 4600 (2400Mhz / 512KB L2 per core) Patriot PDC22G5300LLK (1GB x 2) 4-4-4-12 Dual Channel XFX 7900GT PCI-E 16x 256MB, NVIDIA 91.47 drivers, 520/750 2@Hitachi 80GB SATA 3.0Gbps Drives RAID-0 NEC 3550A CD/DVD RX OCZ GameXStream 600W Power Supply * * ========== [b]Genie BIOS Settings:[/b] [color=red] CPU Clock Multiplier ............ - X 12 CPU/C51 HTT Frequency............ - Auto CPU/C51 HTT Multiplier........... - Auto C51/MCP55 HTT Frequency.......... - Auto C51/MCP55 HTT Multiplier......... - Auto PCI-E Slot4 Clock................ - 100Mhz PCI-E Slot1 Clock................ - 100Mhz CPU VID Control.................. - Auto CPI VID Special Add.............. - Auto C51 NB Core Voltage.............. - 1.20v MCP55 SB Core Voltage............ - 1.50v MCP55 SB Standby Voltage......... - 1.5v CPU/C51 HT Drive Strength........ - Low, Low CPU/C51 HT Voltage............... - 1.30v C51/MCP55 HT Voltage............. - 1.30v DRAM Voltage Control............. - 1.85v [/color] [b]DRAM Configuration Settings:[/b] [color=red] Memclock Tri-Stating............. - Disabled Memory Hole Remapping............ - Enabled Auto Optimize Bottom IO.......... - Enabled DRAM Drive Strength.............. - Level 15 RAM Drive Weak/Normal Mode....... - Auto CLK Enable Drive Strength........ - Auto Chip Select Drive Strength....... - Auto MEM Address Drive Strength....... - Auto MEM Clock Drive Strength......... - Auto Memory Data Drive Strength....... - Auto Data Strobe Drive Strength....... - Auto CS/ODT Pin Fine Delay............ - Auto SLI-Ready Memory................. - Disable Timing Mode...................... - Manual Memory Clock Value/Limit......... - 400Mhz Command Per Clock (1/2T)......... - 1T CAS Latency Control (Tcl)........ - 004 CLK Min RAS Active Time (Tras)....... - 012 CLK RAS to CAS Delay................. - 004 CLK Row Precharge Time (Trp)......... - 004 CLK RAS to RAS Delay (Trrd).......... - 003 CLK Row Cycle Time (Trc)............. - 021 CLK DIMM 1 Row Refresh (Trfc0)....... - 075 ns DIMM 2 Row Refresh (Trfc1)....... - 105 ns DIMM 3 Row Refresh (Trfc2)....... - 075 ns DIMM 4 Row Refresh (Trfc3)....... - 075 ns Read Precharge Time (Trtp)....... - 002 CLK Write Recovery Time (Twr)........ - 005 CLK Read to Write Delay (Trwt)....... - 004 CLK Write to Read Delay (Twtr) ...... - 003 CLK Refresh Period (Tref)............ - 03.9 us Max Asynch Latency............... - 006 ns Bank Interleave.................. - Enabled DRAM On-Die Termination.......... - 075 ohm Read Delay From Rx FIFO.......... - 2.5 CLK Read/Write Queue bypass.......... - 08 time Bypass Maximum................... - 04 time 32 Byte Granularity.............. - 64-Byte Idle Cycle Limit................. - 16 Dynamic Counter.................. - Enable Read DQS Skew.................... - Auto [/color] ========== Orthos (SP2004) + 3dMark2001SE + 2x CPU-Z + Everest Ultimate 3.5: http://myweb.cableone.net/mondo/screen3.JPG 3dMark2003: 3dMark2005: 3dMark2006: ========== short description: 200x12 @ 2400mhz 1.375vcore / 1.85vdimm 4-4-4-12 Share this post Link to post Share on other sites More sharing options...
Recommended Posts