DFI lanparty UT ultra-D hangs on windows startup if ONCHIP USB is enab

[X-Treme]

Hi everyone!

 

I don't know if there is already a thread for this problems but there it goes!

 

After assembling my computer i tried to reapair windows so i configured to boot up from cd-rom drive, then i started windows setup but it just keept hanging on the transition fase betheen loading the setup and asking what to do next and what HDD to choose windows to be installed or repaired, so i searched for some solutions on some forums and found that desabling the ONCHIP USB whas the solution, but not quite right, after completly formating the HDD and installed a fresh windows xp sp2 i enabled ONCHIP USB again started windows and installed nForce Chipset Driver's, restarted and the system handed on the same place AGAIN, so i just disabled ONCHIP USB again, then windows just starts fine, but if i enable ONCHIP USB it hangs, does someone have the same problem? Does someone know a solution for this?

 

-----------------------------

MB: DFI Lanparty UT Ultra-D w/ BIOS NF4LD406 2006/04/06

CPU: AMD Athlon 64-Bit 3700+ San Diego

GPU: GeCube ATi Radeon X1800GTO 256MB DDR3

RAM: 2GB DDR Corsair Value Select (2x1GB)

HDD: Western Digital 250GB Sata 2

PSU: LC Power Silent Power 550W PCI-E Ready

CD/DVD: LG DVD-RW 16x Dual Layer

OS: Windows XP SP2