Quat3rMain

Hi,I just went from 2 512 sticks of muskin redline xp4000 to 2 1g sticks of the same,since then i started getting problems the last thing i did to get my rig to work was change my bios to 12-7-05 .Is there any reason why 2 1gig sticks would not work with the most recent bios?

Still yet to run the 3dmarks,i will do that when i get home...

I have ran the OCCT test for 1 hour with no problems also have done the aquamark3 and a system stability test that comes with Ntune and the only time that i had probles was when i crancked the FSB to 240.

Yeah i just saw that i'm bring it back down to 116%,thank you for catching that. what about the other settings do the look ok? Any sudgestions on the FSB on how to get it higher maybe around 250:confused: ? And another Question is it better to have a higher FSB and a lower multiplier or the other way around,how would i get better performance?

Here is what i have done Genie BIOS Settings: FSB Bus Frequency............................. - 235 MHz LDT/FSB Frequency Ratio....................... - x 4.0 CPU/FSB Frequency Ratio....................... - x 12.0 PCI eXpress Frequency......................... - 100Mhz CPU VID StartUp Value......................... - StartUp CPU VID Control............................... - 1.325V CPU VID Special Control....................... - Above VID * 121.6% LDT Voltage Control........................... - 1.20V Chip Set Voltage Control...................... - 1.56V DRAM Voltage Control.......................... - 2.84V DRAM Configuration Settings: DRAM Frequency Set (MHz).................... - 200=RAM/FSB:01/01 Command Per Clock (CPC).................... - Enable CAS Latency Control (Tcl).................... - 3.0 RAS# to CAS# delay (Trcd)................... - 03 Bus Clocks Min RAS# active time (Tras)................... - 08 Bus Clocks Row precharge time (Trp).................... - 03 Bus Clocks Row Cycle time (Trc).................... - 12 Bus Clocks Row refresh cyc time (Trfc)................... - 16 Bus Clocks Row to Row delay (Trrd)................... - 03 Bus Clocks Write recovery time (Twr).................... - 03 Bus Clocks Write to Read delay (Twtr)................... - 02 Bus Clocks Read to Write delay (Trwt)................... - 03 Bus Clocks Refresh Period (Tref)................... - 3120 Cycles Odd Divisor correct........................... - Disable DRAM Bank Interleave.......................... - Enabled DQS Skew Control.............................. - Auto DQS Skew Value................................ - 0 DRAM Drive Strength........................... - Level 08 DRAM Data Drive Strength...................... - Level 1 Max Async Latency............................. - 07.0 ns DRAM Response Time............................ - Normal Read Preamble Time............................ - 05.0 ns IdleCycle Limit............................... - 256 Cycles Dynamic Counter............................... - Disable R/W Queue Bypass.............................. - 16 x Bypass Max.................................... - 07 x 32 Byte Granularity........................... - Disable(4 Bursts) System is running Stable @ 2.82 Aquamark 3--114,376 My only concern is that my video card came already OC'ed at 550/1200 once i overclocked everything else my video card went to 550/792 is this normal. I tried new drivers and nothing happen tried ntune i cand get it to 600/850 stable but the 1200 memory i can't reach,like i said i'm new to overclocking so i might be a stupid question but i don'r know if it ios or not..