Eraser
Members-
Posts
20 -
Joined
-
Last visited
Eraser's Achievements
Newbie (1/14)
-
Yes, defult ON, but only the bios after 12/31 I believe allow you to change the CPC setting.
-
I believe you can solve your problem by disable CPC, becuase lots of ram with two banks as yours cannot stable when CPC enabled. CPC, conmand per clock, under all of the ram setting, disable it and try again:p
-
My SUPER PI is 39s, 2s slower than yours, please help me. thanks. :eek:
-
I just solve your problem by turn off the CPC
-
Infinity NFII board drops LAN
Eraser replied to zorbo's topic in Processors, Motherboards and Memory
My suggestion is simple, grab a $15 PCI Network card -
Why my Lanparty UB cannot stable at even FSB200
Eraser replied to Eraser's topic in Processors, Motherboards and Memory
The thing is I have seen lots of test before, compare with 2225, 2-2-2-11 will increase the bandbandwidth but lower the overall performence, seems 2225 or 2226 is the best setting. -
I am sorry, as you seen in the pic on the top, My ram is 512x2 and double side. I open them before, so I pretty sure about that. Thanks for your time, I will use DC to take some BIOS screen shot later, thank you so much:angel:
-
Why my Lanparty UB cannot stable at even FSB200
Eraser replied to Eraser's topic in Processors, Motherboards and Memory
Thanks, After I turn off the CPC, everything goes fine, I set the voltage to 3.2v and boost my BH5 to 250mhz 2225. how wonderful! -
I am sorry, I add my sign below
-
The thing is when I enable the CPC, the system will become really really unstable even at FSB200. TOO BAD, but could you tell me how to optimize my bios setting? The DFI'S BIOS is so complicated. thank you so much? :cat:
-
I pushed my Athlon-M to 250x10 and set ram to 2-2-2-5, but still need 40s. I think should be the bios setting problem, anybody can tell me how to set my bios to optimize my computer, thanks a lot
-
I am using the 619 bios, please tell me where it is, thank you so much
-
I want disable the CPC but I can't find the place, thanks a lot.
-
Why my Lanparty UB cannot stable at even FSB200
Eraser replied to Eraser's topic in Processors, Motherboards and Memory
Hi, could you tell me where is the CPC? I can't find it, and my model is khx3200, I know it is BH5 because I opened the heatsink:nod: -
Why my Lanparty UB cannot stable at even FSB200
Eraser replied to Eraser's topic in Processors, Motherboards and Memory
Because it stable and primeable at 1.72v 166x15 (2.5ghz), I don't think voltage is the problem