chenzhong

ok thank you for the insight.i understand now.dam ssd does not really worth the cost.

why not? i read on the review ssd should load windows within 30 sec as standard.

this is my benchmark still windows loading time is over 35secs any thing i can do to improve it other than msconfig and the powercfg -h is off.

no i didn't change any port.i think i put it to sleep by accident.

great! how do you turn sleep off?i just press shut down and dont know how i put it to sleep.

OK this is strange,this morning when i turn on my computer,there is no bios load screen and it only took 9.1 Secs to load the windows fully. and i don't remember what i did to make it skip bio and boot the computer so quick.(other than disable steam and enable quick boot on)but i am happy with the time now.

i am bit confused on this one,on my device manager. the ide ata/atapi controller is intel sata ahci controller but the storage controller is Marvell 91xx sata 6G controller does this mean the z68 onboard controller is not 6G?

yes i did i enable it on both control,how do you change to generic windows AHCI driver?

Kingston don't suggest run benchmark on new ssd straight after fresh install,they say it will wear ssd.should i?

i have Intel rapid storage technology install may be that is make my ssd slow? its from the disc come with mobo

ya the marvell do initializ from start and how do you disable steam?

what about you install 16G of staff onto your ssd to see how long does it take. mine took 20 min. 555MB/s should only take 32 sec.

logo to fully loaded take 36 secs i dont have password

ok i just install shogun 2 on my new hyper x ssd 16G took 20 min.there must be something wrong with my ssd.should i contact kingston for a rmd? because it is under performing? i am sure i am using the 6G sata port on the mobo. i am using the z68 on board control for my ssd which is the mid port sata port 0 and 1 can some one double check for me please

from windows logo takes 36s to load up