Jump to content


original-jedi

Member Since 10 Jul 2010
Offline Last Active Jan 03 2011 02:30 PM
-----

Posts I've Made

In Topic: 3DMark Competition

30 August 2010 - 03:28 AM

It says to run 3dmarkVantage at default setting, what would that be? entry level or performance and at what res?

In Topic: HAF 932 Fans

10 August 2010 - 02:11 PM

i'm going to test things out with the rear fan as exhaust and if i don't like it i'll probably end up throwing the PSU back on the bottom. I want to compare the 230 up top to having three 120's in top to see how that fairs. I'm going to leave the 120 in the back because it has a good bit higher CFM than the stock 140, and i don't mind noise that much.


You should place your PSU at the bottom with the fan down to exhaust its own air out of the case and add the 120m next to it the same way, that way all that warm air coming out of the Graphics goes straight out and you do not have the warm air of the psu blowing in towards the graphic card. Like the guys said, keep the back pulling air out and the top, the front and side as intakes, that is what most of us that have HAF 932 have it set up. You can also add that 140mm that you aint gonna use in the front (drive bays) to pull additional fresh air in, I did that as well. as far as the top 230mm you can replace for 2 120mm with more CFM together if you need to do so. I learned all that here with countless reads and massive advice from the folks here.

In Topic: How to Post Pictures

10 August 2010 - 11:56 AM

Or save them as jpegs (.jpg)

Tried it to no avail my prt scr shots are over 1900x1000 and did not know how to save as 8 bit. Nice little program though.

In Topic: 3DMark Competition

09 August 2010 - 11:12 PM

this with a bit of oc on the hd5850;

In Topic: 3DMark Competition

09 August 2010 - 07:23 PM

Updated! Except for Jedi, since I can't read what's written on the screen.


Sorry for the size of it, I just learned how to post this, hope you can see better now.