Hi,
Does Scythe Ninja SCNJ-1000 fit into LanParty nF3 Ultra-D motherboard?
I've heard that the Ninja is too big and getting in contact with some circuits of the MB causing problems. Is that so?
Someone in some forum somewhere (don't remember which, read so many...) mentioned that you can use the MB's backplate instead of the Ninja's. Does it work?
And then there's this heat sink review in the following link which claims that you can install Ninja without removing the MB. They used LanParty nF3 as a test board. http://www.madshrimps.be/?action=getarticl...681&articID=406
Any experience/knowlidge anyone? Any workarounds?
Thanks,
zackry
