Jump to content

quailbert

Members
  • Posts

    4
  • Joined

  • Last visited

quailbert's Achievements

Newbie

Newbie (1/14)

  1. Alright, i'm going to try out those settings. I just tried to run prime in x64 at stock speeds. 200fsb x 10 multi for 2000mhz and RAM at 2-2-2-5 1T timings @ 2.8 volts. I had to boost the stock voltage to 2.8, just for it to boot into windows. Prime ran for a while but then I got a blue screen. That's not right. I can't even get it to run stable in x64 at stock. I think I'm gonna try to reinstall windows if the other settings dont work either.
  2. The install went smoothly, no blue screens. I haven't checked event viewer, I'll check it right now. Everything looks fine. I just see "information" bubbles and some warnings here and there, but that's regarding my DHCP.
  3. I've overclocked my cpu to 270 * 10 and my TCCD RAM runs on a 1 to 1 ratio at 2.5-4-7-3. I've run Prime for 16+ hours perfectly fine in 32-bit windows. However, I can't even get it to boot into windows x64 most of the time. I've put the ram on a 7/10 divider (so that'd be less than DDR400) and it still won't boot into windows. I tried using really slow timings and it still didn't help. I also tried lowering the FSB to 250 leaving everything else the same but that was still no good. If I ever got it to boot into windows, it only ran prime for 4-7 minutes before failing. I played with my CPU voltage, using 1.45v-1.6v. I tried changing my RAM voltage from 2.7-2.95v (I run stable using 2.95v in 32-bit). Could it be that my windows install is bad? I think that's the one thing that I haven't tried, reinstalling windows. Any help is appreciated, thanks for reading.
×
×
  • Create New...