Jump to content

madgravity34

Members
  • Posts

    52
  • Joined

  • Last visited

madgravity34's Achievements

Newbie

Newbie (1/14)

  1. I just finished re-doing my h20 loop today so I set up my system (see sig) just like usual and booted. The board does something really strange however, all 4 LED's come on then it goes to 3 then back to 4 and the 4th LED flickers for a second and the board shuts down. Anyone seen this issue before? Help would much appreciated.
  2. Yes it was, timings are at 2.5-4-3-7. Voltages set to 2.8v in bios. Sorry about the pics guys, Ill will re-size them once I get home.
  3. I recently upgraded to a kit of teamgroup bh-5 UTT so I no longer need these sticks. They are in perfect condition and have never had thier heatspreaders removed so they are still under OCZ's AWESOME lifetime warranty. They clocked great on my Ultra-D, I am sorry for not being able to give more recent pics but I can only go off what I was able to do with my single-core which I sold. My new cpu cannot run this memory to thier true potential. The screenies show two speeds that I ran with a 9x multiplier on my 3700+: 311 and 315, I also did runs at 318mhz but I dont have any screenies. The ram was never run past 2.8v (bios setting) and it was always actively cooled. In fact, I have been running it in my system until 5 days ago when I recieved my teamgroup. PICS of RAM: SCREENIES: I am looking for 130 shipped for this ram. This is a great clocking set! I accept non-cc paypal and have heat under madgravity34 PM here or email me @ [email protected] TRADES: I would consider a trade for an ABO DFI EXPERT as thats what I am looking to raise money for. Thanks again.
  4. No offense, but some of you guys looking into getting a high clocking dual-core should looking into the x2 3800+. Mine does 2.75 @ auto in bios and 2.95 @ 1.48 volts. I am on water however, they are really nice chips.
  5. I am interested in a trade for my OCZ rev. 2's but your pm box is full! CLEAN IT OUT!!! Lol...
  6. Image quality not so different and temps are much better with the 7900gtx's. Also, if you guys thing ATI's cooler is bad I have seen plenty of posts over at Xtremesystems and Ocforums where guys have installed the new VF9 zalman cooler and they get higher load temps than the stock cooler! The only aftermarket HSF that can really lower the heat are the accelero x2's but those fill your case with hot air. I am going with the 7900gtx because it clocks higher with lower temps so I can still keep pushing my dual-core CPU to its limits.
  7. This card has essentially been sitting around in my closet. It was given to me by a close friend of mine and I used it for a few days before I decided I didnt need it. I am selling it for a good price to anyone interested in a good deal...hehe... PICS As you can see the card and drive are in perfect condition with no scratches or any damage. Think of this as essentially OEM as I dont have the original box or driver cd, but you can download the drivers easily. I want 100 USD shipped within the US. I accept paypal and have heat under madgravity34.
  8. Bump... @zeimbo I dont have enough posts over at ocforums to get to the FS section lol.....I just became a member over there.
×
×
  • Create New...