Saigak
Members-
Posts
8 -
Joined
-
Last visited
Saigak's Achievements
Newbie (1/14)
-
Which bios do you use? I had the same problem with stock 1/25 bios. Try to boot with one stick and flash 3/10 bios or later. Check my sig for ram voltage and timings.
-
Bios Recommendation for RAM OC?
Saigak replied to Scrufdog's topic in Processors, Motherboards and Memory
May be it helps... -
Bios Recommendation for RAM OC?
Saigak replied to Scrufdog's topic in Processors, Motherboards and Memory
Mucker, try to raise voltage to 3,2v and you'll be able to run 235 sync stable at 2-3-2-5. My system run stable at 245 2-3-2-5 with 3,4v with the same LLK memory. Good luck! -
Bios Recommendation for RAM OC?
Saigak replied to Scrufdog's topic in Processors, Motherboards and Memory
My chipset is so hot cause i don't like annoying sound of it's cooler and i set my smartguardian to turn it on at 50c. if i set it spinning at low temp- it about 43-45 at full load. I hope raising RAM voltage will help you. -
Bios Recommendation for RAM OC?
Saigak replied to Scrufdog's topic in Processors, Motherboards and Memory
Bios 3/10, chipset at 1.5v and what about temp... i think if there is no memory errors - then the temp is normal - system is 8h prime stable. I think ram is well cooled by zalman 7700. BTW chipset temp is 50c. Yesterday i tried to memtest at 250-260- and only at 270 there was errors.... not tried to boot windows at that frequencies yet. -
Bios Recommendation for RAM OC?
Saigak replied to Scrufdog's topic in Processors, Motherboards and Memory
I have two 512m sticks of the same ram - it runs stable at 245 2-3-2-5, but i had to raise voltage up to 3.6-3.7v. -
What power supply do you have? (open to all platforms)
Saigak replied to Angry_Games's topic in OCC Member's Lounge
360w that came with chieftec dragon case. -
Patriot 1G Stick no good?
Saigak replied to InsaneLunatic's topic in Processors, Motherboards and Memory
Sorry i use nf4 ultra-d. -
Patriot 1G Stick no good?
Saigak replied to InsaneLunatic's topic in Processors, Motherboards and Memory
Hi! I have two sticks of the same memory pdc3200llk but both are 512Mb. With stock 1/25 bios i was able to boot only with one stick. After flashing to 2/18 dual channel is ok. Now i'm on 3/10 official. My memory likes high voltage - its running sync at 250 2.5-3-3-6 at .... 3,7v . So try to flash last bios and to raise voltage - at 3.2v highest was 235 2-3-3-5.