Chevelle

524 !!!

524

Here is a link for volt mods. http://www.malvescorner.com/nfii.html

Just a little up date with my situation. I has seen somewhere that someone said that the Drive Strength and Slew Rate was 3/10 on the Abit NF7 boards. I had my 1 GB of BH-5 stable up to 235 on one. So I decided to change it to those settings on my Infinity, and bam !!. Priming right now at 240x10.5 :nod: using 2-2-2-2-11-13-15-E-E-F-D-3-3-5-3-3-3-3 3-11-A-A-3-11. So my advise is to try changing the Drive Strength and the Slew Rate. Will post a pic when Im done priming :nod:. I had it stable with 3-10-A-A-3-10 at 235x10.5. I tried changing the 3 to a 4 and no go at 240. Tried changed it back, changed the 10 to a 11 and still priming :nod:. Also I tried put the stick in slots 2-3 and lots of memtest errors !! Even tried 1-2 lots of errors. So my board like slots 1-3.

Im having the same problem also. I can run my BH-5 (2x512MB) one stick up to 250FSB all completely stable. Tried each stick, both ran up to 250FSB stable. But when I tried DC, its a no go. I can boot and everything, run games, benchmark. But prime crashes within 36sec every time. Here is my setup: AMD XP-M 2500 1.75v SLK-947U w/92mm Panaflo 56cfm DFI Ultra Infinity 6/19 Bios Mushkin Promo BH-5 1GB (2x512MB) 3.3v ATi 9500NP@9700 418/300 1.5v vGPU 1.74v Antec True430W