mckennaiii

i'm in the u.s.

maybe i better rethink using the dfi boards. really don't have time for lots of problems. the dfi 875 board i had was flawless and o/ced a 3.0es to 3.75 Please put location in.

Sig created. thankx for the heads up on that.

would the expert model be the next best choice for a opty 165?

anyone know where this is for sale?

would this be a good choice? http://www.newegg.com/Product/Product.asp?...N82E16817104934

has anyone tried this combo?

i had planed to use it on the dfi lanparty pro 875b board. since i can't go abovr 2.9 dimm volts, will the ocz vx still work ok?

thankx.

will this work on the dfi lanparty pro 875b?

has anyone tried the geil golden dragon with the dfi 875 board?

which ballistix should i get to use with this board and a 3.0es? pc3200 or pc4000

from anand tech dfi board review. Filling all three available memory slots is more strenuous on the memory subsystem than testing 2 DIMMs on a motherboard. We were very pleased to find that 3 DS DIMMs (1.5GB) of memory worked fine at timings almost the same as the aggressive timings that we used for 2 DIMMs. The DFI is one of the few Socket 754 boards that we have tested which can handle 3 DS DIMMs. You do need to use slightly slower timings with 3 DIMMs, but the 2-2-3-10 is very close to the rated 2-2-2-10 timings of the memory which we used for testing. Stable DDR400 Timings - 3 DIMMs (3/3 DIMMs populated - Single-Channel mode) Clock Speed: 200MHz CAS Latency: 2.0 RAS to CAS Delay: 3T RAS Precharge: 10T* Precharge Delay: 2T Command Rate: 2T

so would i be better off just using 2x256 especially if i want to o/c?

can i use 3x256 mushkin pc3200 level II bh5 on this board?