Jump to content
Sign in to follow this  
Guest Kronos_merged

OCZ 2GB (4 x 512MB) 184-Pin DDR SDRAM DDR 500 OCZ5001024ELDCGEVX-K

Recommended Posts

Guest Kronos

I'm now running my system with OCZ 2GB (4 x 512MB) 184-Pin DDR SDRAM DDR 500 OCZ5001024ELDCGEVX-K. Installation was of course was a snap (2 snaps actually). I forgot to turn off Command Per Clock (CPC) before I booted up the first time so my system didn't post. ;) I quickly removed the extra sticks of RAM and remedied that. I didn't need to change anything else in my setup.


I'll most likely continue to run my system as per my specs below. BUT, I'm more than willing to listen to any suggestions out there. I did notice the drop in benchmark scores, but I believe that the REAL WORLD gains will more than make up for that. Let's face it benchmarks are great for . matches, but I build my systems for myself and not to impress the masses.



Short description:

250x11 @ 2750Mhz, 1.300v + 123%

2-2-6-2 @ 3.3v vdimm

BIOS 5-10-3


Genie BIOS Settings:


FSB Bus Frequency - 250

LDT/FSB Frequency Ration - Auto

CPU/FSB Frequency Ratio - X 11.0

PCI eXpress Frequency - 100Mhz


CPU VID StartUp Value - StartUp


CPU VID Control - 1.300v

CPU VID Special Control - Avove VID * 123%

LDT Voltage Control - 1.20v

Chip Set Voltage Control - 1.50v

DRAM Voltage Control - 3.30v


DRAM Configuration Settings:


DRAM Frequency Set - 200 (DRAM/FSB:1/01)

Command Per Clock (CPC) - Disable

CAS Latency Control (Tcl) - 2.0

RAS# to CAS# delay (Trcd) - 02 Bus Clocks

Min RAS# active time (Tras) - 06 Bus Clocks

Row precharge time (Trp) - 02 Bus Clocks

Row Cycle time (Trc) - 07 Bus Clocks

Row refresh cyc time (Trfc) - Auto

Row to Row delay (Trrd) - 02 Bus Clocks

Write recovery time (Twr) - 02 Bus Clocks

Write to Read delay (Twtr) - 02 Bus Clocks

Read to Write delay (Trwt) - 03 Bus Clocks

Refresh Period (Tref) - 4708 Cycles

Write CAS Latency (Twcl) - Auto

DRAM Bank Interleave - Enabled




DQS Skew Control - Auto

DQS Skew Value - 0

DRAM Drive Strength - Level 8

DRAM Data Drive Strength - Level 4

Max Async Latency - Auto

Read Preamble Time - Auto

IdleCycle Limit - 256 Cycles

Dynamic Counter - Disable

R/W Queue Bypass - 16 x

Bypass Max - 07 x

32 Byte Granularity - Disable(8 Bursts)

Share this post

Link to post
Share on other sites

Care to do some comparisons in games? I know the extra 1GB makes a world of difference in BF2, I'm curious if the extra GB makes up for having to disable CPC in regular games like Half-Life 2, Far Cry, Doom 3

Share this post

Link to post
Share on other sites
Guest Kronos

I'll post some comparisons after I'm done with my new OC Database entry. My new entry for 4X512MB 2T along with my current entry for 2X512MB 1T will give you a good picture on the differences between the 2.


I should be done with my OC entry by tomorrow.

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Create New...