No signal to monitor

[Guest DaVe]

Today i bought a Zalman cpu cooler ( the copper one that looks like a flower ) i had to take out my mobo to install it due to the back plate thing. Ok so i installthe cooler and everything goes just greatl

 

But then ! I plug everything back in and turn it on, i get no signal to the monitor the fan on the gfx card still spins.

 

I reset my bios with no luck.

[thejwt]

remove the 20/24 pins connector from the mobo wait for 20 sec and then aswell clear youre cmos, plug the cable back and that should do the trick

 

if not i fear the worst for you

[Guest DaVe]

thanks for your reply, i tried that with no luck,

the cpu fan and one of my case fans sometimes stop or run verrrrry slowly

[Guest DaVe]

i have also tried moving ram about and trying with on stick etc

[red930]

Have you tried reseating the card?You sure it's making good contact w/new cooler?

[Guest DaVe]

the cooler i bought is a cpu cooler not a gpu one, and yes i have tried reseating the card

[thejwt]

thanks for your reply, i tried that with no luck,

the cpu fan and one of my case fans sometimes stop or run verrrrry slowly

did you try removing the battery aswell?

[Guest DaVe]

yes i did, only one red led lights up and the cpu fan stops spinning