Errors in memtest at stock with tweaked rgone settings.

[Wraithetc]

Hardware in sig

 

I keep getting 2 errors in test 7 no matter what. I set the dimm voltage to 3.1 which is the minimum voltage I can get it to boot but other than that i'm using rgones settings.

 

Memtest reads the errors as 00003c6ffb0 60.9mb

 

good: 536d5b8c bad:136d5b8c errorbits:40000000

 

I think this is the cause of my computer randomnly rebooting itself after exiting a game like UT2004. It bsods while changing resolution, the error is the IRQ equal or less thing.

[oliveryochest]

increase voltage to memory

[cpuz]

I have read that value ram is not recommended w/ a top performing board as you are using. But try olivery's suggestion anyway. Also, you could try another bios.

[Guest burningrave101]

I have read that value ram is not recommended w/ a top performing board as you are using. But try olivery's suggestion anyway. Also, you could try another bios.

 

It all depends on what your looking at as to whether or not value memory is any good. OCZ Value VX uses UTT-BH chips now which is the same chips used in the OCZ PC3200 Gold. The Value VX overclocks quite well.

 

He probably just needs to increase the voltage, burn in the RAM or tweak the DRAM settings. The tREF, Data Strength, and Data Drive Strength settings are especially important.

[Sharp]

Hello,

 

Try these

 

Try setting the memory voltage to 2.8v.

Chipset voltage = MAX out

LDT voltage = MAX out

HTT/FSB = 200Mhz (no overclocking)

 

Ratio = 1:1

Command per clock...............Disable

Cas latency...........................2

RAS to CAS delay..................3

Min RAS active time...............6

Row precharge time..............3

Row cycle time......................11

Row refresh cycle time..........14

Row to Row delay.................3

Write recovery time...............2

Write to read delay...............1

read to write delay...............1

Refresh period.......................AUTO

Wrtie CAS latency..................1

DRAM bank interleave.......... .Enabled

 

DQS Skew Control.............................Decrease Skew

DQS Skew Value................................0

DRAM Drive Strength..........................AUTO

DRAM Data Drive Strength..................AUTO

Max Async Latency.............................6ns

Read Preamble Time...........................5ns

Idle Cycle Limit...................................AUTO

Dynamic Counter................................Enable

R/W Queue Bypass.............................AUTO

Bypass Max.........................................AUTO

32 Byte Granularity.............................Disable(8 Bursts)