Also dualchannel boot problems (BSOD) with my Lanparty Nf4 ULTRA

[I-eye]

Hi DFI-users,

 

I'm also experiencing troubles with my DFI motherboard and memory in dual-channel setup.

 

Looking on the internet, and here, I found several possible sollutions but none are working so far.

 

Current setup is corresponding with the settings Corsair recoommends: 2.7V 2.5/3/3/6... Toying around with the voltage settings doesn;t help... I've put them up to 2.8, 2.9 and 3.0: each time while XP64 is starting up in the firts screen it gives a BSOD with several error messages: MEMORY_MANAGEMENT, IRQL_NOT..., DRIVER_IRQL... etc.... Flashed to the latest official BIOS, but no solution.

 

I'm using the 2nd and 4th bank as reccommended. In single-channel setup it does work?

 

I hope someone has the same config that I use and could tell me their settings, hoping that works for me as well.

 

It seems that a lot of customers report these symptoms, wil there be a definitive official solution from DFI for this behaviour?

 

Menno.

[dspayre]

Have you tried using only 1 stick in the orange slot furthest away from the cpu? (slot2).

 

Try and test each stick to see if it passes memtest. Once you pass several hours on each stick, try them both in the two orange slots. Run memtest again for several hours.

 

Once you pass those, your system should be ready to install the OS. Just to make sure, are all 4 power cables connected to the mother board?

[I-eye]

One dimm in bank 2 works fine... That's how I installed XP64

 

I've only attached the ATX (24 pins) powercable... Have I overlooked others?

 

I will try running memtest for several hours this weekend. But what if I get errors... how can I interpret these and know what settings to adjust?

[Alphamale]

There are 4 power connection that must be made on the board. the 24atx, the 4 pin, the molex and the floppie power connector. IF you look at the mother board manual you will see where they are located.. Plug them all in

[I-eye]

will check tonight... I'm working now....