Jump to content
Sign in to follow this  
Clocker

NF3 Ultra-D 939/AGP

Recommended Posts

Motherboard:

LANPARTY UT nF3 ULTRA-D

Motherboard BIOS:

ud602

Memory:

Samsung 2 x 256 1 x 512

Video Card:

xfx 6600 GT

Share this post


Link to post
Share on other sites
Motherboard:

LANPARTY UT nF3 ULTRA-D

Motherboard BIOS:

ud602

Memory:

Samsung 2 x 256 1 x 512

Video Card:

xfx 6600 GT

 

Copy and paste the above into yer siggy under the user control panel.

 

You can't run "odd" number combos. Either 1 stick, 2 sticks or 4 only...According to Rgone that is due to the memory controller (on yer processor, don't blame the board ;) )

Share this post


Link to post
Share on other sites

is there anywhere to buy this board in the UK?

 

or should i get another 939 board not DFI?

Share this post


Link to post
Share on other sites
Ok, I tried 9x300 with 133 divider and 3xHT multi. but it didn't boot. It booted at 9x290 though. I'm gonna try the same thing but with 8x300 and see if it works.

 

Pick a number and stick with it for awhile ;) If you booted at 9X290 increasing yer voltage a tad will probably get you 9X300...All moot though as you will most likely be unstable there. Most can boot at ungodly speeds but they are nowhere near stable. Work yer way up and test in between otherwise yer settin yerself up for disappointment....

Share this post


Link to post
Share on other sites
Ah that sucks.

 

Look on the bright side...Gives you an excuse to buy another 512meg stick of "TCCD"???????

Share this post


Link to post
Share on other sites
How much should I increase vcore? Not much if it booted at 290 but not at 300, right.

 

Need to know where yer at with current settings...Keep in mind some people have had trouble with manually adjusting voltage and are or were stuck using only the "voltage increase" function.

Share this post


Link to post
Share on other sites

Is the northbridge fan noisy on this board?

 

If it is, is it possible to change the fan speed through BIOS or SmartGaurdian?

Share this post


Link to post
Share on other sites
How much should I increase vcore? Not much if it booted at 290 but not at 300, right.

 

 

increase the HTT voltage to 1.75 or 1.85 if going over 290 HTT, it helps stability quite a bit.

 

Try keeping AGP on 68Mhz if going over 300.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...