Jump to content
Sign in to follow this  
AdminRUFF

RGone i need your help ASAP!

Recommended Posts

hello. well i have been told to read your one post to help me out on some of my non skilled over clocking.lol i have printed it out and went and did it.

http://www.dfi-street.com/forum/showthread.php?t=5866

the only thing was i have the hammer witch takes more volts so insted of 1.42 i had to go to 1.500 on both. but see i know ur going to laugh and tell me i did some thing wrong. i did everything it said in that post and i only get 1.20MHZ :confused: i dont understand why has it dropped it 1/2 way. stock i run at 2.21 and when i clock the fsb to i think 214 i get a stable 2.31 but i seen alot of ppl that have like 3.0. thats why im looking to get. im going to keep my system to this bios setting till i get a reply from you just in case you know what to change. if you want to know a little more about my system here is a link:

http://www.dfi-street.com/forum/showthread...7033#post107033

if you or anyone can help please do ;)

Share this post


Link to post
Share on other sites

you might need to go in and set your cpu multi becuase it looks like its at 4 or 5 depending on what fsb your using. i believe your cpu should be at 11xmulti. did you mix up the ldt and cpu ratio.

Share this post


Link to post
Share on other sites

no i didnt mix anything up. there is a couple of posts and pic i have seen and tryed them and stuck my MHZ way down.

 

UPDATE:

i did change it back to almost stock. with them settings i couldnt even get into 3dmark05. it took 10 min for it to load.

Share this post


Link to post
Share on other sites

i havent seen anything like that yet, what bios are you running and is that a 24 pin power supply. i havent used that corsair ram so i dont know what kind of timings it would like. hopefully rgone or angry will see this thread and help you out.

Share this post


Link to post
Share on other sites

What are your settings exactly, don't want to find it funny, but dont worry its prob a silly mistake anyone can make.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...