Need help OC LP 925X-T2

[Some0ne_DK]

HI All

 

I would like some advice with my OC... when ever i go over 250 FSB i cant get a stabel system... with 240 FSB it runs perfekt... and can go prime95 for 2h with any problems.

 

My current bios config is :

Overclok

 

Advance Bios Features

 

APIC mode Enabled (what is that)

MPS version control for OS 1.4 (1.1 what is the diff)

 

Advance Chipset Features

 

Dram timing Selectable By Spd ( 4-4-4-12)

SLP_S4# Assertion Width 4 to 5 sec

System Bios Cacheable Enabled

Video Bios Cacheable Disable

Dram Data integrity mode Non-ECC

 

Performance mode Normal (disable-normal-turbo-ultra-extrame)

 

Integrated Peripherals

On bord Device

 

Onboard PCI-E LAN Enabel

 

 

Genie Bios Setting

 

FSB 240

PCI-E FQ Auto

N/B Strap cpu as by cpu (FSB800)

Minimize FMB15 COU Ratio Disabel

Dram type Auto (DDR400/DDR553)

 

CPU Volt 1.3875v

Dram V 1,8v

Nb 1,5v 1,6v

Auto Detect PCI Clk Enabled

Spread Spectrum Disable

 

I read this thread http://www.dfi-street.com/forum/showthread...&highlight=925x but i dosent help me out

 

What do i do wrong ?

[saperboy]

If you want to OC to 250FSB, you'll have to change the PCIe freq from AUTO to 115MHZ.

 

But if you want to OC to more than 250FSB (i.e. 289FSB ) then you'll have to remove your PCIe graphics card get a PCI graphics card and then set your PCIe freq to AUTO.

 

Always have your NB volt to 1.6v and no more than that.

[Some0ne_DK]

OK tnx for the help

 

Got it up to 248 FSB now

[saperboy]

^ no prob. glad I could be of help. thanks for the update.