nforce RAID on sli dr

[markost]

Hi Guys

 

whenever i attempt to install windows using the nforce raid controller, I get blue screened just as windows is about to ask for the EULA when you press F8.

 

I've changed hard drives, cables, powerconnectors with no change. The Silicon Image controller works fine. I can however make a raid set in windows with the hard drives attached to any of the sata ports 1,2,3 or 4.

 

I can't create a raid set(nforce chip) to use as a data partition either. I still get blue screened....and.... BIOS always wants to boot into the nforce raid set.

 

Any suggestions !!!!!!!

 

Cheers

 

By the way, this text comes up on the bluescreen....

 

Remove any newly installed hard drives or hard drive controllers. Check your hard drive to make sure it is properly configured and terminated, and then restart your computer.

 

Technical Information: ***STOP: 0x0000007B (0xF7C79524,0XC0000034,0X00000000, 0X00000000

[Angry_Games]

please check the rules and the Important Info threads stuck to the top of this section.

 

If you are looking for help, reading this is the most important first-step for you to take.

 

this helps us tremendously to help you solve your issue if we can see what is in your system every time you post:

 

 

 

PLEASE SEE THIS LINK!:

http://www.dfi-street.com/forum/showpost.p...701&postcount=2

 

 

 

Be as thorough as possible please. Voltages, timings, settings, bios version, etc.

 

The more information you give us about the problem, and the more details about your hardware in your sig = more help we can give you.