lh6461 Posted October 27, 2004 Posted October 27, 2004 Every time I try to go to 230x10 or above I get the bsod. My temps are excellent. Memory is at 2.5-2-2-10. Anyone have any idea what is going on. I bought the dfi and the ocz ram because they are supposed to oc well. I need more experienced help. Quote Share this post Link to post Share on other sites More sharing options...
stowenrat Posted October 27, 2004 Posted October 27, 2004 quote Angry Games since it is a known issue that SATA 1/2 either will corrupt or wont boot when FSB is past 240, we are testing right now whether you can fresh load Windows (2k/XP) on 3/4 with only 3/4 enabled. Quote Share this post Link to post Share on other sites More sharing options...
IT.F.R.O.M. Posted October 27, 2004 Posted October 27, 2004 Try the enable/disable option for the CPC. Try with 2T Or raise up you're cpu voltage, or ram voltage Quote Share this post Link to post Share on other sites More sharing options...
Angry_Games Posted October 27, 2004 Posted October 27, 2004 some more info on your settings, voltages, timings, ratios....would probably help more than just saying 'i got a problem getting over 220...help me' Quote Share this post Link to post Share on other sites More sharing options...
lh6461 Posted October 27, 2004 Posted October 27, 2004 I posted my mem timings above, and I forgot it is at 1t. My voltages are default and are now within specs. I am trying to set it at 230x10. I run stable now with everything on auto and default except for the memory which is set at 2.5,2,2,10. Anything I am leaving out. Quote Share this post Link to post Share on other sites More sharing options...
JazzMang Posted October 28, 2004 Posted October 28, 2004 I'm no expert at the NF3 chipset, but at 230 MHz 1:1, your EB (at stock voltage) will probably need a drop to CAS Latency 3, b/c at that point you are reaching PC3700EB specs. Don't expect it to run at stock timings/voltage at a higher FSB with no issues. If you are wanting to overclock a lot, you need to realize that at higher speeds, most components will need higher voltages/looser timings (usually the case - not always) Remember to raise the voltage in moderation if you are an inexperienced overclocker. JazzMang Out. Quote Share this post Link to post Share on other sites More sharing options...
Gibjee Posted October 28, 2004 Posted October 28, 2004 Like IT.F.R.O.M. said, try raising vdimm voltage and cpu voltage and possibly even chipset voltage. Also, like Angry_Games said, post more info about your bios settings. It's hard to help when we dont know anything about your setup. Quote Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.