whimp Posted December 8, 2005 Posted December 8, 2005 (edited) i changed the voltage on my processor by accident and i was just windering if there was a way to rest the bios without pulling my battery my computer will no longer turn on EDIT Nevermind Edited December 8, 2005 by whimp Share this post Link to post Share on other sites More sharing options...
bigred Posted December 8, 2005 Posted December 8, 2005 1: need more info (what motherboard) 2: RTFM. read the manual, it's in there Share this post Link to post Share on other sites More sharing options...
Kamikaze_Badger Posted December 8, 2005 Posted December 8, 2005 Clear CMOS jumper, or take the battery out and put it back in.* *And, regarding the rumor that you have to wait ten minutes or so: No, you don't, at least not in my experience. Electricity "decays" VERY fast, so it only takes a second at the MOST to reset your BIOS by taking out the battery. Share this post Link to post Share on other sites More sharing options...
bigred Posted December 8, 2005 Posted December 8, 2005 of course unplug the comp from the wall if you go the battery route Share this post Link to post Share on other sites More sharing options...
Kamikaze_Badger Posted December 8, 2005 Posted December 8, 2005 And that helps too . Share this post Link to post Share on other sites More sharing options...
ir_cow Posted December 8, 2005 Posted December 8, 2005 of course unplug the comp from the wall if you go the battery route 592208[/snapback] i wonder if anyone ever forgot that, what a shock that would be Share this post Link to post Share on other sites More sharing options...
ady1989 Posted December 8, 2005 Posted December 8, 2005 EDITNevermind 592166[/snapback] ok Share this post Link to post Share on other sites More sharing options...
cheesewiz6 Posted December 12, 2005 Posted December 12, 2005 Actually wouldn't be a bad shock just might damage the comp because it would be a very low current and its the amps that will kill you and since I have never seen a psu with amprage over 40 at 12 volts you would be fine. Share this post Link to post Share on other sites More sharing options...
NinjaDude Posted December 12, 2005 Posted December 12, 2005 Usually you can remove the Battery for several minuites and put it back in and there ya go Share this post Link to post Share on other sites More sharing options...
Nerm Posted December 12, 2005 Posted December 12, 2005 Normally I just pick it up and shake it a little and everything magically resets itself. lol hahaha Share this post Link to post Share on other sites More sharing options...
Psychotic_god Posted December 12, 2005 Posted December 12, 2005 Normally I just pick it up and shake it a little and everything magically resets itself. lol hahaha 595449[/snapback] LOL , My mobo has a jumper that lets me clear Cmos without taking out the battery. Wait....is Cmos and BIOS the same? I thing Cmos is the DFI bios right? Share this post Link to post Share on other sites More sharing options...
Ste Posted December 12, 2005 Posted December 12, 2005 (edited) LOL , My mobo has a jumper that lets me clear Cmos without taking out the battery. Wait....is Cmos and BIOS the same? I thing Cmos is the DFI bios right? 595499[/snapback] The CMOS and BIOS are not the same, However most people refer to the CMOS as the BIOS. The BIOS is a separate chip then the CMOS. BIOS= Basic input/out System, the programming on the BIOs is physically burned into the chip. The only way to change anything on the BIOS is if its EEPROM, you would flash the BIOS. CMOS= Complementary Metal Oxide Semi Conductor. The setting in the CMOS can be changed through the CMOS setup. The CMOS stores data ranging from Boot sequence and time to Memory timmings and CPU frequency. The CMOS needs a constant voltage to maintain its settings, this is why there is a lithium coin cell battery near it. This is also why we can clear the CMOS by taking out the battery. Much older computers actualy had double A batteries to maintain the CMOS . Edited December 12, 2005 by Ste Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now