Jump to content

Vantec Nexus (nxp-101) Multi-function Panel


Bosco

Recommended Posts

  • 9 months later...

Instructions for setting the audible alarm on the Vantec Nexus fan controller:

 

Remove case screws for case side panels

Remove securing screws for the Vantex nexus and slide component out just far enough that the rear of the unit is accessable

Place knife blade between Piezo speaker and circuit board

Twist knife blade until piezo speaker pops out and onto the floor

Replace unit into case and reinstall side panels.

Power up computer and ensure all connected fans are still operating.

 

Presto!

 

This procedure is recomended by Daggar to all those who purchased this product from a vendor who's taken no consideration into the vast number of CPUs, heatsinks, cooling fans, and operating tempetures resulting from the limitless combinations of all the forementioned.

Share this post


Link to post
Share on other sites

×
×
  • Create New...