serv Posted September 30, 2004 Posted September 30, 2004 (edited) Does the REV 4 silencers fit over a 9800 PRO that has ramsinks on ? just curious about to buy 1 of these fans.. and 1 more thing, when using some arctic silver 5 for the gpu, can this compound be used for fixing the ramsinks to the memory chips ? or do i need some arctic (alumina/silver) adhesive ? as well Edited September 30, 2004 by serv Quote Share this post Link to post Share on other sites More sharing options...
kewlboxer2 Posted September 30, 2004 Posted September 30, 2004 vga silencers r ok, but i would go with the heatpipes one, the airflow over the heatsink isnt much Quote Share this post Link to post Share on other sites More sharing options...
r_target Posted September 30, 2004 Posted September 30, 2004 I haven't seen a Rev. 4 yet; I have a revision 3 and can only use small heatsinks on the Silencer side of the card. The other side is wide open though. Arctic Silver 5 is not adhesive, so you would need a different solution-thermal glue or tape. Quote Share this post Link to post Share on other sites More sharing options...
worker Posted September 30, 2004 Posted September 30, 2004 Heard a lot about vga silenters in the past should be able to find it in the arcives of cooling on this site. Quote Share this post Link to post Share on other sites More sharing options...
serv Posted October 1, 2004 Posted October 1, 2004 Arctic Silver 5 is not adhesive, so you would need a different solution-thermal glue or tape. so this AS5 wud be used for seating REV 4 silencer and GPU ? and the arctic (alumina/silver) adhesive for the Ramsinks yeah ? Quote Share this post Link to post Share on other sites More sharing options...
Hyper Threaded Posted October 2, 2004 Posted October 2, 2004 Don't get any AS5 outside the GPU chip, as it is slightly capacitive (will build a charge). I recommend either using the stuff that comes with the cooler, or Arctic Ceramique because they're safer. Quote Share this post Link to post Share on other sites More sharing options...
serv Posted October 2, 2004 Posted October 2, 2004 ah dang, the REV 4 ATI 1 VGA silencer doesnt fit properly whilst havin Ramsinks fitted, so im gonni have to cut a part of the silencer case.. Quote Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.