whitefiretiger Report post Posted September 28, 2018 Toying with the idea of etching a design into a plexi case window and edge lighting it but can't seem to find anything that's been done before to help figure out a good way to do this. Any help would be great. Sent from my SM-G950U using Tapatalk Share this post Link to post Share on other sites
Braegnok Report post Posted September 29, 2018 There are some different ways to do it without having access to a Co2 laser cutter, using etching cream, acetone, but tracing over the image using a cordless dremel seems about the easiest way,.. and using LED strips or light tape. Sounds like a fun DIY project. 1 Share this post Link to post Share on other sites
whitefiretiger Report post Posted September 29, 2018 Thanks. I may give it a try. There are some different ways to do it without having access to a Co2 laser cutter, using etching cream, acetone, but tracing over the image using a cordless dremel seems about the easiest way,.. and using LED strips or light tape. Sounds like a fun DIY project. Sent from my SM-G950U using Tapatalk Share this post Link to post Share on other sites
whitefiretiger Report post Posted September 30, 2018 Gave the dremel idea a go and it came out great. Next will be ordering a red led strip. Sent from my SM-G950U using Tapatalk Share this post Link to post Share on other sites