Jump to content

P10000 3D MARK11, OCed Budget X-79 $1500 build

Recommended Posts



have not got over a 9000 score currently have gpu 1.2v/1.618v mem, 1100MHz/1575Mhz(6300), Afterburner is maxed as far as frequency spectrum goes I have seen 1250/7600 on the web. I believe that a water-block and radiators would be needed to run that all the time without wearing out the fan on the heat-sink.


The side fan I have configured through speed fan to turn on and ramp up after 50C GPU temp. The GPU fan will not turn on until 50C. I figured this would save the lifespan of both fans as well as reduce noise, and dust intake. Haven't got around to getting a correct filter for the side intake. My homemade one was full of fail. Any suggestions?

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...