Overclocking Issues - hitting threshold?

[crazyman62]

i have a AMD 5000+ brisbane in a MSI K9N NEO V3

and since this is a stock 2.6GHz proccessor, i have decided to get adiquite cooling and push it.

im running windows 7 ultimate

with 2GB of DDR2 ram, stock 1066MHz. but when OC'd its only running at 965 because the motherboard does 800MHz stock (kinda old, and will upgrade when money comes my way)

 

im currently running 3.1GHz stable, @ 13x multiplier, 1.325 V @ 10○C

with spread spectrum disabled.

 

when i go to 3.1GHz it will run OK, but 2 min after running CPU burn in for 1 min, it will lockup.

 

but as soon as i move the FSB up one more MHz the bios handover will be OK, and will try and boot into my user account, then bluescreen

i have done a memtest and everything is normal.

 

im lost on what to do.

[crazyman62]

anybody? anything?

[Boinker]

Here is the actual link to your Chip. ( i put in the black edition)

 

That will help you for a while. Whats your maximum temperatures at load?

 

Also, what is your NB, HT, memory and SB voltage set too?

 

Also try to put more power too it. Though Im pretty sure those chips maxed out around that area. good luck there.

Edited December 15, 2009 by boinker

[crazyman62]

under load temp is 22○C

 

my hyperthreading is set to

1000MHz

16 up 16 down

and i cant change the voltage of the NB and SB

they are set to auto

[Boinker]

ok. Check in CPU-ID and make sure that the HT isn't running above 1200 and change it too 800 if its above that. (that helps to have it close to 1000). and put the juice to it.

 

BTW what options can you change?

Edited December 15, 2009 by boinker

[crazyman62]

ok. Check in CPU-ID and make sure that the HT isn't running above 1200 and change it too 800 if its above that. (that helps to have it close to 1000). and put the juice to it.

 

BTW what options can you change?

 

http://www.easycom.com.ua/data/mboard/7122140/img/b1.jpg

is what my bios voltages section looks like, (this is not mine) im @ work, so i dont have a pic of it

i have also tried my HT on auto wich set it to 900MHz

Edited December 15, 2009 by crazyman62

[Boinker]

sorry if I am not being of much help right now. trying to multitask while checkiong on my WC set-up. Its been a while sense I have broke out the old Athlon 64 and overclocked the crap out of it so I am a bit rusty. im sure you can crank a little more out of that chip but I couldn't tell you much further instructions from here. best of luck. ill search the web for a guide on that chip while im still awake.

[crazyman62]

ok thank you

[bldegle2]

"and i cant change the voltage of the NB and SB

they are set to auto"

 

>>>>>>>>>>>>>>>>>>

 

normally the drop down will display options, the 'auto' you spoke of usually can be changed to manual, then voltage options become visable, prolly the same for your NB v's...

 

if you made a sig, people would have more informations to go by...

 

laterzzzz.............

Edited December 15, 2009 by bldegle2