Bad Setting Make My Rig Unstable?

[gustie]

The CAS latency is dependant on your memory, as you listed 3-3-3-8 in your sig you can only set it to 3. (2.5 might work)

As to why is says 3T, I can only assume that DFI programmed the BIOS like this.

If it was the command rate is would say Command Rate and options would only be 1T or 2T.

 

Your aggressive/expert settings might be what determines the command rate.

The AGP latency setting is something that you need to play around with and use something like 3Dmark to find out which setting gives the best results.

To low might not be enough time and to high can cause a decrease in performance, but this setting will not cause instability.

 

 

cheers

 

changed CAS to 2.5 runs ok

 

AGP aperature on 64 - guess a few hours on PRIME95 will tell...