Jump to content
Sign in to follow this  
ShadeZeRO

Bad contact with mobile cpu?

Recommended Posts

Hey everyone....

 

When I first recieved my mobile cpu my temps were around the ~30*c (low to high). Load never really went past 41*c

 

Right now, I'm idling at 47*c! I'm not sure how to go about fixing this problem. Should I completely remove my HSF and reapply paste?

 

I know the screws dont hold my CPU fan in, i had to use tape because i have a vantec tornado now.

 

I'll post a pic when I can.

 

422474idle.JPG

543171DSC03955.JPG

659986DSC03956.JPG

506756DSC03957.JPG

 

Edit:

I removed the HSF, seemed as if I put too much AS5 on it. Cleaned it out, was extra carefull this time not to put too much. Also put a new fan on it (one that fit with the screws.

Lookin good so far, 39*c, but it's sitting on it's side right now. I think i'll keep it like that until the AS5 cures?

 

Update again:

If I put the tower back up, it raises temps back to 45*c

Prime95 @ 62*c max (with AC on, 59/60*c)

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...