Crabs Posted December 14, 2007 Posted December 14, 2007 ill start off with systems specs then layout the problem DFI Lanparty UT 590 SLI + latest bios athlonx2 4200+ Windsor(2200 mhz each Core) 2 GB Gskill 6400 ddr2 5 5 5 15 Configured in dual Channel 2x Leadtek px8600 GTS 675/2000 Ultra Xpro 600 watt ATX SLI ready single Rail +12V 36 Amp WinXP Pro servicePack2 along with latest Forceware(just downloaded) problem persists Yes the SLI Bridge is Installed Yes SLI is enabled Yes power is connected to the 4 Pin FDD near the Primary PCI express Yes both Cards are plugged into the 6 pin Yes im using the full 8 pin EPS connector my Problem is No matter what I run, bench Mark wize 3dMark05, Fear benchMark etc.. I score the Same 11- 12k (3dmark05) similar Bracketed results in Fear bench mark etc.. with a second card Installed as i do with a single card... Receiving NO sli Improvement whatsooever. ... every runs OK, Im just seeing No enhancement from the Second card, Ive tested them both Individually and they both score Similarly Also, I get NO video from the Lower Card I was under the impression i should is this an incorrect assumption? Im basicly lost over this problem and was wondering if anyone else had encountered something atleast Similar and found a Remedy Quote Share this post Link to post Share on other sites More sharing options...
radodrill Posted December 14, 2007 Posted December 14, 2007 Not familiar with that board; but there may be a BIOS setting you have to change to enable SLI. Quote Share this post Link to post Share on other sites More sharing options...
nailzs Posted December 18, 2007 Posted December 18, 2007 There should be something in the NVIDIA control panel that needs to be checked for SLI, I think. Quote Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.