radodrill Report post Posted August 11, 2007 Drilled screwholes into the first side panel Same for the other side panel Screwholes and fill-port hole in the top panel Introducing the Dremel's big brother Screwholes, drainport, and air intake slots in the bottom panel Test-fit assembled outer panels; had to sand some of the corner blocks and panels to achieve a perfect fit Sponsors: Quote Share this post Link to post Share on other sites
taowulf Report post Posted August 12, 2007 I like the masking tape look. Quote Share this post Link to post Share on other sites
radodrill Report post Posted August 12, 2007 I like the masking tape look. LOL; It'll look a lot better when it's done :nod: Quote Share this post Link to post Share on other sites
taowulf Report post Posted August 13, 2007 LOL; It'll look a lot better when it's done :nod: I am sure it will. The preparation so for is impressive. Quote Share this post Link to post Share on other sites
Guest SuppA-SnipA Report post Posted August 14, 2007 haha wow this looks promising Quote Share this post Link to post Share on other sites
radodrill Report post Posted August 14, 2007 haha wow this looks promising Thanks; I'm looking forward to the finished product. Quote Share this post Link to post Share on other sites
radodrill Report post Posted August 15, 2007 Yesterday I received the pushbutton switches for this case; some ring-illuminated momentary switches, dot-illuminated latching switches, and a non-illuminated momentary switch I added some stops to the panels to ensure flush edges Laid out the back panel Cut out back panel Fitted into the back of the case Sponsors: Quote Share this post Link to post Share on other sites
red930 Report post Posted August 15, 2007 what are you useing for glue on the plexieglass ? Quote Share this post Link to post Share on other sites
radodrill Report post Posted August 15, 2007 what are you useing for glue on the plexieglass ? I'm using Polycarbonate Cement SC-325 available from US Plastics. I use a bottle w/ a 25 Ga needle to apply it ("plasticator"); just clamp the parts together, and apply it at the seam. Quote Share this post Link to post Share on other sites
red930 Report post Posted August 15, 2007 thats a sweet looking case Quote Share this post Link to post Share on other sites
radodrill Report post Posted August 15, 2007 thats a sweet looking case I think so too It'll be even better when it's finished and has a high end gaming rig in it. Quote Share this post Link to post Share on other sites
radodrill Report post Posted August 16, 2007 This Morning I received a package from A.C. Ryan containing fans, CCFLs, and wire sleeving supplies Time for some eye-candy Kameleon Fan; translucent black under normal light And Blue under UV With the fan on: Red Twin Overburst CCFLs UV Twin Overburst CCFLs And the money shot Fan and wire sleeving in full UV splendor: Sponsors: Quote Share this post Link to post Share on other sites
