ISSA2000 Posted April 11, 2007 Posted April 11, 2007 my 3.3v sensor via mbm5 or via bios screen health.. is now saying 1.09v. psu tested shows 3.3v and system is fully stable... i have 2 boards (expert) iv rip out my new d rev board and put in the replacement c version.. its ok....shows 3.3/// 3.28 etc.. i have mbm log file every 60 sec.... why has my sensor gone wrong... show i send it back under warrenty its 5 months old.. how long is the warrenty.. Share this post Link to post Share on other sites More sharing options...
Sharp Posted April 11, 2007 Posted April 11, 2007 Hello, 1 year warranty from date of purchase. Yeah send it back. Did you recently flash the bios? Share this post Link to post Share on other sites More sharing options...
ISSA2000 Posted April 11, 2007 Posted April 11, 2007 no...new board came with last known up to date bios.... just downloading...checking email then...mbm5 warned me of low voltage.. i though faulty software glitch... but same in bios.. actual now its saying .098 volts before it was 1.09 boards never been clocked... at 4800 + 1900xtx it does every thing i need.. no mods on it..stock standard....everything heatsink etc... last board that died (11months old) had a th 90c heatsink... but i decides it was not warthy to clock t as i cant get rid of the heat via air cooling....and i needed a rock stable setup... i only run bf2 - 2142 for a few hours a week...rest of the time...print invoices etc...watch dvds.. Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now