Someguy333 Posted March 28, 2007 Posted March 28, 2007 I just measured my voltages on my PSU using a multimeter. My 3.3v and 5v were ok, I'm pretty sure. Going from 3.40-3.42 and 5.10-5.12. That's through idle and load. my 12v is a little more, at load was 12.07-12.10 and at idle was 12.16-12.17. It also moved from as low as 12.05 to as high as 12.18, those came when I started to shutdown. Basically I don't know if these are reliable enough. I just switched to an Opty 165 and I'm starting to OC it. Everything else is still as listed in my sig. Share this post Link to post Share on other sites More sharing options...
Polizei Posted March 28, 2007 Posted March 28, 2007 My Antec has loose tolerances and its at 5%... yours are not even 2% off. They are well within spec... dont worry. Share this post Link to post Share on other sites More sharing options...
Someguy333 Posted March 28, 2007 Posted March 28, 2007 Ok, thanks I don't really like the idea of damaging any of my components. Share this post Link to post Share on other sites More sharing options...
davidhammock200 Posted March 29, 2007 Posted March 29, 2007 I just measured my voltages on my PSU using a multimeter. My 3.3v and 5v were ok, I'm pretty sure. Going from 3.40-3.42 and 5.10-5.12. That's through idle and load. my 12v is a little more, at load was 12.07-12.10 and at idle was 12.16-12.17. It also moved from as low as 12.05 to as high as 12.18, those came when I started to shutdown. Basically I don't know if these are reliable enough. I just switched to an Opty 165 and I'm starting to OC it. Everything else is still as listed in my sig. No worries here. :angel: Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now